How to Full Field a Chrysler Alternator
Full fielding a Chrysler alternator is a process that involves reconfiguring the alternator’s internal components to optimize its performance. This procedure is often performed to improve the alternator’s output, especially in older models where the stock alternator may not be able to provide sufficient power. In this article, we will guide you through the steps to full field a Chrysler alternator, ensuring that you achieve the desired results.
Before you begin, it’s essential to gather the necessary tools and materials. You will need a socket set, a wrench, a screwdriver, a multimeter, a heat gun, and a replacement diode kit. Additionally, make sure you have a clean, well-lit workspace to work on your Chrysler alternator.
Step 1: Disconnect the Battery
Before starting the full fielding process, it’s crucial to disconnect the battery to prevent any electrical shocks or damage to the alternator. Use a socket set to remove the battery terminals, ensuring that the negative terminal is disconnected first.
Step 2: Remove the Alternator
Locate the alternator in your Chrysler vehicle and disconnect any electrical connections. Use a socket set to remove the bolts holding the alternator in place, and carefully lift it out of the engine bay.
Step 3: Inspect the Alternator
Once the alternator is removed, inspect it for any signs of damage or wear. Check the diodes, brushes, and slip rings for any issues. If you find any problems, replace the faulty components before proceeding.
Step 4: Remove the Diodes
Using a socket set, remove the diode holder from the alternator. Carefully disconnect the diodes from the holder and set them aside.
Step 5: Install the Replacement Diodes
Install the new diode kit into the alternator. Ensure that the diodes are properly aligned and securely fastened to the diode holder. Replace the diode holder and secure it to the alternator with the bolts.
Step 6: Reconnect the Electrical Connections
Reconnect the electrical connections to the alternator, including the battery terminals. Make sure all connections are tight and secure.
Step 7: Test the Alternator
Reinstall the alternator in your Chrysler vehicle and reconnect the battery. Use a multimeter to test the alternator’s output, ensuring that it is functioning correctly. If the output is as expected, the full fielding process is complete.
By following these steps, you can successfully full field a Chrysler alternator and improve its performance. Remember to take your time and work carefully to avoid any damage to the alternator or your vehicle.
